sample strength

To taste, sample, or otherwise test in order to determine strength, effect, worth, or desirability.

试验,尝试尝试, 取样或侧试以决定力度, 效果, 价值或受欢迎程度.

网络文摘精选

An Experimental Study on Tensile Strength of Irregular Rock Sample by Sleeve Fracturing Technique

不规则岩石试件抗拉强度的套筒致裂试验研究

互联网摘选

It was found that at low injection rate the tensile specimen has the best performance for both tensile strength and impact toughness; at low melt temperature, although the tensile properties of the sample is better, but its impact toughness is reduced.

研究发现，低注射速率条件下试样有最优的拉伸性能与冲击韧性；低熔体温度条件下的试样虽然拉伸性能较好，但其冲击韧性反而降低。

互联网摘选

The coking test was made on coal sample with the same blending ratio and different bulk densities, the relationships between coke abrasion strength, crushing strength, apparent porosity, coke reactivity index, coke strength after reaction and charging bulk density were obtained.

采用同一配煤比和不同的装煤堆密度煤样进行炼焦试验，得出焦炭的耐磨强度、抗碎强度、显气孔率、焦炭的反应性、反应后强度与装煤堆密度的关系。

互联网摘选

Evaluation of the life by means of the shear strength of sample which pass through heating oxygen aging test according to environmental test specification was.

以拉剪强度为特性指标，通过热氧加速老化试验，参照环境考核试验，综合评估其使用寿命。

互联网摘选

The synthetic method of HIPS inserted nano-MMT was studied, the impact strength and the tensile strength of the sample were measured, the structure appearance of the sample's impact cross section was observed.

研究含纳米蒙脱土的高抗冲聚苯乙烯（HIPS）的制备工艺，测试了试样的冲击强度和拉伸强度等力学性能，观察了试样冲击断面的结构形态。

互联网摘选

Comparative study on the result of experiment, the sample shows that the RPM and PNM could predict the strength of ship accurately.

通过与实验值的比较，说明简化方法与塑性节点法都能较准确预报极限强度。

互联网摘选

The inspection results indicated that the uniform diameter of pure sand-gravel columns in mud and silt reached 55~ 82 cm, and the boring core sample strength of grouting column reached 4.3~ 11.4 MPa at the age of 28 d.

检测结果表明，挤入淤泥和粉土中的纯砂砾柱平均直径达到55~82cm，28d龄期时水泥砂砾灌浆体取芯的抗压强度达到4.3~11.4MPa。

互联网摘选

A method of bundle strength test by manual blending sample in different blending ratio

混纺试样束强测试中的实验方法

互联网摘选

In this paper taking No. 40# axle steel as the test material the writer chose two kinds of shot peening strength for peening the test sample.

以40＃车轴钢为试验材料，选择了两种不同的喷丸强度对试件施喷。

互联网摘选